T2 Wireless thermostat
Pairing the R2 to the SmartLife App:
Ensure your R2 is within range of your router.
Your mobile phone MUST be connected to the 2.4GHz wifi signal issued by your router.
The pairing process will not work if you are connected to a 5GHz wifi signal, or to your
phone’s
cellular (e.g. 4G) network.
On the main screen of the SmartLife App:
1)
Add device by pressing the + button in the top right corner.
2)
Select
“Small
Home
Appliance”
from the menu on the left and select
“Thermostat”
from the options on the right.
3)
Check the SSID shown is your network and enter its password.
4)
Press and hold the BOOST button on the R2 until LED1 rapidly flickers red.
5)
On the App, press
“Confirm
indicator rapidly
blink”
.
6)
Pairing is complete when the Red LED on the R2 stops flashing. The App may
continue to search for the connection for a few seconds longer and when
finished, will leave you in the management screen for the R2. You can
experiment at this point entering commands (e.g. temperature up or down) from
the App or the T2 and the R2 will respond a few seconds later.
About the Smartlife App
The Smartlife App is constantly evolving and future versions may have some
differences to these printed instructions which were correct at time of printing. You
can always find the most up to date version of the instructions by checking the T2 /
R2 product pages on the Herschel website, where there is a link to the most up to
date instructions.
Clearing all pairing
To use R2s with a different T2, clear all pairing by pressing the Power button and
BOOST button together on the R2 for 5 seconds. LED1 and LED2 will both switch on
and will switch off when you release your fingers.
Signal lost
If the R2 loses wifi connection, LED 1 will flash red slowly. It will continue to work
with the T2, but the LED will continue to flash red slowly.
