Hermida Audio Technology Pedal Quick-Start Guide
Page 4 of 5
Dual Boost Pedal
The Dual Boost pedal
(Diagram D)
offers two distinct clean gain
levels selectable by a footswitch.
The Dual Boost has the following configuration:
1.
Gain A, Gain B, Tone and Voice knobs
2.
In/ Out jacks
3.
9V DC adapter jack
4.
Status On/ Off LED and Gain A and Gain B LED indicators
5.
Bypass footswitch (true bypass) and A/ B toggle footswitch
6.
9V battery clip (located inside the unit)
Dual Boost Pedal Operation
1.
Install a battery or DC adapter plug into the unit and connect the audio signal from a
guitar or another pedal to the
In
jack. Connect the
Out
jack to another pedal or
amplifier.
2.
The Status LED (lower middle) indicates if the unit is active (LED is On) or in bypass
mode (LED is Off).
3.
The Gain A and Gain B LED indicators are located under the corresponding Gain
knob. One of the two LEDs should always be On when there’s power supplied to the
unit. The LEDs indicate which Gain channel will be active when the Status LED is On.
4.
The Gain A and Gain B knobs are independent of each other and the A/ B footswitch
can only select A or B.
5.
To fully bypass the unit, press the On/ Off footswitch. The Status LED should turn
Off.
Diagram D
: Dual Boost pedal
