background image

Herman Miller Ode Lamp

Assembly Instructions

5

Part # 1BGH00 Rev. C 

Place lamp on desired floor location, making sure power supply and cord are 
properly routed. Plug power supply into a standard electrical outlet.

Step 11

For more information about our products and services please visit us at  
hermanmiller.com or call (800) 851 1196. 
©2019 Herman Miller, Inc., Zeeland, Michigan Printed in U.S.A.  Part No. 1BGH00
® 

Y

 and Herman Miller are among the registered trademarks of Herman Miller, Inc.  

™ Ode is among the trademarks of Herman Miller, Inc.

To operate lamps: 

Grasp any part of the stem to 
turn lamps on or off. 

NOTE: By design light automatically shuts  
off after nine hours.

For Example: The light is turned on and runs for 
two hours before being turned off. The light is then 
turned on again so now it will continue to run for 
an additional seven hours and then will turn off 
automatically.

Note: After connecting power to 
the unit, there will be a 5 second 
delay before the lamp can be 
turned on via touch sense.

Содержание Ode

Страница 1: ...Driver Phillips Screw Driver 1 8 Allen Wrench 1 8 Allen Driver Bit Phillips Driver Bit Parts Included Tools Required How to assemble your floor lamp A Shade Weldment C Column Assembly Top Bottom B Lamp Head Assembly Base Assembly D Head Hardware 4 Flat Head Screws 3 M6 Lock Nut Set Screws Mounting Plate Insulator Power Supply E Hardware HermanMiller Ode Floor Lamp F Shade Support Hardware OR ...

Страница 2: ...washer before it is installed the screw with ring terminal must be securly tightend to ensure conductivity to the post Step 4 Step 5 Step 6 Plug the wire connector into the side of PCB driver board The screw with ring terminal must be securly tightend to ensure touch sense conductivity Screw the shade mounting plate into the lamp head assembly using four flat head screws Make sure that the wire is...

Страница 3: ... onto the mounting plate Step 7 Feed wire through central hole of base assembly Studs set screw Step 8 Step 9 Step 10 Attach base assembly using three Allen head screws Make sure that the insulator is installed between the base assembly and the screws Connect power supply cord to floor lamp ...

Страница 4: ...GH00 Y and Herman Miller are among the registered trademarks of Herman Miller Inc Ode is among the trademarks of Herman Miller Inc To operate lamps Grasp any part of the stem to turn lamps on or off NOTE By design light automatically shuts off after nine hours For Example The light is turned on and runs for two hours before being turned off The light is then turned on again so now it will continue...

Отзывы: