Herman Miller Ode Lamp
Assembly Instructions
3
Part # 1BGH00 Rev. C
Set lamp head assembly into place on top of the column.
Step 3
Install three pan head machine screws around the shade support. The ring
terminal on the wire must be installed on one of these machine screws with
internal tooth lock washer before it is installed the screw with ring terminal
must be securly tightend to ensure conductivity to the post.
Step 4
Step 5
Step 6
Plug the wire connector into the side of PCB driver board.
The screw with ring terminal must
be securly tightend to ensure touch
sense conductivity.
Screw the shade mounting plate into the lamp head assembly using four flat
head screws. Make sure that the wire is underneath of this plate.
Atta
ch ri
ng te
rmin
al w
ith
scre
w h
ere. T
ighte
n se
cure
ly.
Exam
ple
:
