Assembly Instructions
3
HermanMiller
1BNX5K rev E
Step 1: Assemble the Foot to the Column
1.1 Assemble using the M10 x 1.5 x 30mm length screws (2 per
column). When torque wrench is available, tighten fasteners to
maximum of 48 Nm. (35 Ft-Lbs.). If you do not have access to a torque
wrench, then tighten fasteners to snug, plus a ¼ turn. .
Step 3: Fasten the Table Frame onto the Table Top
3.1 Be sure to use approved screws per the table top supplier.
3.2 Repeat step 3 and tighten.
Note:
Some holes may need to be pre drilled.
Full Length
Independent
Step 2: Assemble Top Support to the Beam and Column
2.1 Assemble using the M8 x 1.25 x 12mm length screws
(4 per column) leave screws loose. When torque wrench is available,
tighten fasteners to maximum of 24 Nm. (18 Ft-Lbs.). If you do not have
access to a torque wrench, then tighten fasteners to snug, plus a ¼
turn. Align top support holes with independent beam assembly. Repeat
as necessary for remaining columns .
Step 4: Fasten the Cross Beam onto the Table Top
4.1 Secure the Cross Beam with the table top with 8 screws.
Note:
Some holes may need to be pre drilled.
