Assembly Instructions
2
HermanMiller
1BNX5K rev E
Before proceeding with the table assembly: All electric motors MUST be
initialized before moving the table in the “UP” direction.
Please follow the below instructions for proper initialization:
•
All Columns (motors) must be plugged into the Control box.
•
Plug the “Up/Down” Hand switch in to the Control box.
•
Plug the Control box power cord into a 110 volt grounded outlet.
•
Hold the “Down” button in until the columns bottom out to the lowest
position.
•
Please continue to hold until a “clicking” sound is heard and the
columns move “slightly” UP.
•
Once this is completed your system is properly initialized and can be
operated without harm to the system.
STOP
Do Not Overload Desk
To prevent table from tipping or collapsing, make sure the desk frame is
not overloaded by the weight of table top and objects on table. Evenly
distribute load; excess loads near edges can reduce stability and lead
to tip over.
•
Do not exceed maximum load (including weight of desktop) of
200 lb. (91Kg) for two-leg configuration.
•
Do not exceed edge load of 25 lb. when positioning monitors or
mounting accessories.
•
Do not sit or stand on table
Use Care When Moving Desk
•
Clear objects and equipment from table before rolling to reduce
the risk of tipping over.
•
Adjust the desk to its lowest height before moving
•
To disconnect, turn all controls to the off position, then remove
plug from outlet
•
Do not move a loaded desk
•
Do not lift the desk by the work surface (desktop)
Do Not Open Electrical Components
Keep Table Frame Dry
Do not attempt to service table components. There are no user-
serviceable parts inside the motor control units or table legs. If
your table needs service, contact customer service. Never operate
this furnishing if it has a damaged cord or plug, if it is not working
properly, if it has been dropped or damaged. Return the furnishing to
a service center for examination and repair.
Keep all electrical components away from water and high humidity.
Clean only with a dry or slightly damp cloth. Do not spray cleaning
solutions directly onto table system.
Grounding Instructions
This product is equipped with a cord having an equipment-grounding
conductor and a grounding plug.
Use only the cord provided
. Make
sure that the product is connected to an outlet having the same
configuration as the plug (as shown in Illustration A) that is properly
installed and grounded in accordance with all local codes and
ordinances.
Do not modify the plug provided with the product - if it will not fit the
outlet, have a proper outlet installed by a qualified electrician.
No adapters are to be used with this product. Keep cord away from
heated surfaces.
Grounding Pin
Grounded Outlet
Grounded Outlet Box
