background image

Z

© 2015 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.

TM

 Locale is among the trademarks of Herman Miller, Inc.

Illustrations and specifications are based on the latest product information available at the time of publication. 
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 

Part no. 1bdpwm rev B.

4

6. Thread the 4” 1/4-20 fasteners through 

the guide holes in the display panel, into 
the studs.

7. Torque to 15 ft-lbs.

D

Disassembly and Recycling:

Materials Identification and Segregation:

Where possible, plastic components are marked with ASTM recycling codes. Use 

these codes to identify material type for recycling. Non-marked components should 

be treated as mixed plastic. Ferrous metals can be identified using a small magnet 

for recycling. Non-ferrous metals should be separated and recycled separately.

To disassemble product, reverse the above installation steps.

Содержание Locale BRMS.FD

Страница 1: ...est product information available at the time of publication The right is reserved to make changes in design and specifications at any time without notice and also to discontinue products Part no 1bdpwm rev B 1 Y Locale Panel Installation and Disassembly for Recycling Instructions Parts Included Storage Panel 4 1 4 20 Fasteners 4 Stud 4 Tools Needed Allen Wrench A B C D ...

Страница 2: ...erved to make changes in design and specifications at any time without notice and also to discontinue products Part no 1bdpwm rev B 2 1 Measure and mark pass through hole on uppercase a BRMS FD i 879 2 mm from the side of the upper case ii 75 9 mm out from the back panel b BRMS PD i 279 2 mm from the outer side panel ii 75 9 mm out from back panel Steps 2 Drill a 1 inch diameter hole at that spot ...

Страница 3: ...n The right is reserved to make changes in design and specifications at any time without notice and also to discontinue products Part no 1bdpwm rev B 3 3 Install panel with vertical stiles to the inside of the unit 4 Using a 5 16 bit drill 4 holes through the center panel using through holes in the new panel as a guide 5 Hammer the provided studs into the new holes in the back of the original pane...

Страница 4: ...dpwm rev B 4 6 Thread the 4 1 4 20 fasteners through the guide holes in the display panel into the studs 7 Torque to 15 ft lbs D Disassembly and Recycling Materials Identification and Segregation Where possible plastic components are marked with ASTM recycling codes Use these codes to identify material type for recycling Non marked components should be treated as mixed plastic Ferrous metals can b...

Отзывы: