2
HermanMiller
Installation Instructions
1BMYW4 rev C
Step 4
Step 3
4.1 Push the Base back into the Support post and partially thread
the T-Nut on to the bottom of the draw rod. Note: If the light is to be
installed parallel to the Chase, the rib on the bottom of the base will be
installed parallel to the reflector assembly. If the light is to be installed
perpendicular to the Chase, the rib on the bottom of the base will be
installed perpendicular to the reflector assembly.
*Very Important: Rib on base will point in same
direction as the light assembly.
3.1 Insert the Draw Rod through the bellville washer and into the
hole in the Stiffener Plate in the Reflector Assembly (note the washer
orientation) and carefully push the draw rod in until it reaches the
bottom.
3.2 The Plastic T-Light Base at the bottom of the Support Post Assembly
may need to be pulled slightly out of the bottom of the post in order to
align the end of the draw rod with the hole in the center of the base.
Step 6
Step 5
6.1 Place the T-Light Cover over the Reflector Assembly. The Cover is
secured with magnets in the Reflector assembly.
5.1 Center the Light over the slot in the Chase and make sure the rib on
the base of the unit is engaged in the slot.
5.2 Make sure the power cord runs into the center channel and out the
side of the unit and is not pinched in the Chase. Tighten the draw rod
to secure the light to the chase - snug plus 1/2 - 3/4 turn (90 to 100
in-lb). Do not over-tighten. Pull up on the light to make sure it is secure
in the slot.
