INSPECTION
Prior to operation a visual Inspection shall be made. Check crusher for leaks, worn or missing parts.
Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed
from use until repairs are made. Contact a factory authorized service center for repairs.
If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for
inspection of the crusher.
An annual inspection by a factory authorized service center is recommended.
OPERATION
Turn the external air supply on.
Verify the pressure gauge on the pressure regulator/filter reads between 100 and 120 p.s.i. Adjust the regulator
as required.
NOTE:
If the external air supply is less than 100 p.s.i., the crusher will operate but the crushing performance is reduced.
Lift the door latch and open the door down to gain access to the crushing chamber.
Place the oil filter(s) to be crushed gasket side down on the bottom of the crushing chamber. Arrange the filters as
follows:
Quantity & Type
Position
(1) Heavy duty filter
Center of ram plate
(1) Auto filter
Center of ram plate
(2) Auto filters
Opposite corners
(3) Auto filters
(2) in back corners and (1) in front center
(4) Auto filters
(2) in back corners and (2) in front corners
For filters over 15-3/4" in height, remove spacers.
Close the door and pull the door latch down securely. The crusher will operate for approximately 55 seconds with an
audible air sound.
Wait until the air flow stops.
WARNING
WARNING
The crushing mandrel may be still moving when the
A crushed oil filter may have jagged metal edges. Use
door is opened. Wait until the mandrel stops before
good industrial work gloves to protect the hands
placing hand in chamber.
when removing a crushed oil filter.
Lift door latch and open door.
Remove the crushed oil filter and dispose of it in an environmentally correct manner.
Page 5 of 8
