Clean rinse
1)
Fill an additional bucket (not supplied) with distilled water.
Note: Reuse the cleaning solution / water mixture until it
becomes tacky to the touch. Dispose of all waste materials
2)
Insert the clean rinse pick up tube located on the left side
according to local, state, and federal regulations.
of the Gun Washer in the bucket.
7)
Empty the paint waste out of the inner filter. Place inner
3)
Set the rinse / agitator switch on the right side of the Gun
filter back on the filter holder for up to 10 uses.
Washer to rinse.
Note: place solid waste onto a piece of cardboard to finish
drying. This will speed the process as the cardboard will
4)
Position the spray gun so the clean rinse nozzle is
absorb the moisture from the paint debris.
inserted into the paint channel of the spray gun.
8)
Close the ball valve. Replace filter bags (P/N 1003348
5)
Squeeze the trigger of the spray gun while lifting up
& P/N 1003351) as needed.
with the gun to send a pressurized flow of clean
water through the gun's paint channel.
9)
Dispose of all waste materials according to all local, state,
and federal regulations.
6)
Return the rinse / agitator switch to the neutral position
when finished.
10)
Wipe inner tank after each use.
7)
Use the air gun to dry off any wet components.
Filtering Dirty water (optional)
1)
Remove the cleaning platform from inside of the tank.
2)
Pour the dirty paint mixture to be recycled into the tank.
Do not exceed the 5 gallon capacity of the tank.
3)
Add flocculant / coagulant to the dirty paint mixture. (Herkules
CoAgent P/N CA01 recommended).
NOTE: Herkules CoAgent recycling coagulant along with inner
and outer filter bags can be purchased online at www.herkules.us
4)
If using Herkules CoAgent P/N CA01, add 1 tablespoon
per 5 gallons of dirty paint mixture.
5)
Set the switch on the side of the Gunwasher to Agitator.
Stir mixture for 30 seconds during agitation. Allow
the dirty paint mixture / flocculant mix to agitate
for 30 to 120 seconds (dependent upon quality of
flocculant). Let the mixture sit for 30 seconds.
Return the agitator switch to the neutral position.
Note: Repeat process if adequate separation does not
occur (dependent upon quality of flocculant).
6)
Open the ball valve to allow the mixture to drain
through the filter bags. The filter bags capture the
paint debris, and the bucket captures the filtered cleaning
solution / water mixture that can be reused for cleaning.
Operation
Filter Outer
P/N 13836
Filter Inner
P/N 13835
fig. 4
Page 9 of 16