Installing the Gun Washer
Place gun washer on a level surface in a properly
ventilated paint mixing room or paint booth.
Grounding the Gun Washer
1)
Connect the ground wire on the gun washer’s pump to a
true earth ground.
2)
Ground all equipment used or located in the gun washer
area.
Connecting the air line
1)
Install a 1/4 in. npt male coupler, that is compatible with
the quick disconnect of your air supply line, into the air
supply port of the filter/regulator (located on the back right
leg).
2)
Connect air line with at least 75 psi to the coupler.
Filter/regulator is preset. Do not adjust.
Adding Water to the Gun Washer
1)
Insert the filter mount frame into the bucket.
2)
Fill the bucket with water until the water level reaches
the bottom of the filter support cross arms.
3)
Connect the large filter bag to the filter mount frame so
that the bottom of the filter is resting on the filter
support.
4)
Insert the small filter bag into the large bag and
connect to the filter mount frame.
5)
Place the bucket under the Gun Washer and insert the
pick up tube between the bucket wall and the filter.
6)
Close ball valve.
Preparing the equipment to be washed
1)
Remove paint cup or paint line and the air line from the
paint gun.
2)
Drain excess paint from cup and gun into a separate container.
3)
Remove all gauges and regulators from painting equipment.
Installation
Operation
Air supply
port
Filter mount
frame
Ball valve
Pick up tube
Fig. 2
fig. 1
Page 7 of 16
