Hold the swivel arm screw on the
underside of the float arm. Insert the
swivel arm clamp from the top of the
inlet valve arm, tighten to secure in
place, screw the float onto the swivel
arm screw, check for free movement
of the float, (ensure the float does not
get caught on the side/back wall of
cistern). To adjust water level rotate
the water level adjustment screw,
turn clockwise to reduce shut-off
level, turn anti-clockwise to raise
shut-off level, secure by hand
tightening the locking nut.
The inlet valve is fitted with a high
pressure seat (white), if water
pressure is low, the inlet valve is
supplied with low pressure seat (red,
attached to the inlet valve arm) that
can be swapped, diagram ‘N’ shows
the internal assembly of the inlet
valve body.
Assemble the 2 bolts as diagram ‘F’ shows,
feed through respective holes & secure
using the metal washer & nut as picture ‘C
Shows. The complete assembly of the
bolted kit is shown in diagram ‘G’. Place the
rubber washer over the threads of the
siphon as shown in picture ‘D’ & feed
through the hole in Cistern. Secure hand
tight using back-nut provided as shown in
picture ‘E’ & tighten further half turn using a
Suitable spanner.
