Installation – 1 Hole Basin Mixer/Bidet
1.
Indices
x2
2.
Screw & Washer
x2
3.
Handle Assembly
x2
4.
Shroud
x2
5.
Valve
x2
6.
Tap Body
x1
7.
Pop Up Rod & Knob
x1
8.
Rubber ‘C’ Shaped plate
x1
9.
Metal ‘C’ Shaped Plate
x1
10.
Backnut
x1
11.
Threaded Rod
x1
12.
Tap Body Seal
x1
13.
Connecting Pipes
x2
14.
Pop Up Waste Assembly
x1
15.
Anti-Splash Assembly
x1
1. Identify all components are present prior to starting installation.
2. Screw in copper pipes (13) and fixing kit rod (7) to tap. Fit the mixer body to the basin/bidet
using the ‘C’ plate fixing kit. The full rubber washer (12) goes between the fitting and the
basin/bidet, and the ‘C’ shaped rubber (8) and metal washer (9) on the underside of the
basin/bidet, to be secured by the threaded tail and backnut(10).
3. Connect the hot and cold supplies. DO NOT OVERTIGHTEN. Soft copper tails can be carefully
bent and cut to length to meet supply pipes.
4. Fit the pop-up waste, with the flat washer below and the shaped washer above the basin/bidet. It
is recommended that a silicon sealant be applied to both sealing faces of washers. The plug height
can be set by adjusting the waste rod (14) and operating rod (7) connecting bracket (14), and the
screw in the base of the plug. If the plug will not stay closed, the friction of the pop up
mechanism can be increased by tightening the nut.
5. Fully open both valves, letting them run for a few minutes to flush out the system and check all
joints and connections for leaks.
7
