9. Position the new joint in its place on the joint cement without pulling the material.
10. Close the door immediately to press the joint into place to ensure a valid seal.
The following joints must be used:
GLASS: 105 cm in length and 5 mm in thickness, (Code J316)
FRONT LEFT DOOR: 82 cm in length and 10 mm in diameter. Low density, black
beading (Code J38…)
FRONT RIGHT DOOR: 120 cm in length and 10 mm in diameter. Low density, black
beading (Code J38)
CINDER TRAY DOOR: 102 cm in length and 10 mm in diameter. Low density, black
beading (Code J38)
SIDE DOOR: 76 cm in length and 6.5 mm in diameter. Low density, black beading.
(Code J14)
C.- GLASS
Do not use your stove if the door glazing is broken. Do not hit or slam shut the front
door.
Where necessary, the door glazing can be cleaned with a Hergóm glass cleaner,
which your supplier will provide.
Never
try to clean the glass when the stove is working or when the glass is hot.
Most of the particles deposited can be cleaned following the cleaner handling
instruction.
To clean difficult particles, open the door, pull it upwards and remove from the stove,
leaving the turning pins in the door. (Be careful to save the pins and the washers to replace
the door).
Place the door on a table or workbench and apply the cleaner to the glass, leaving it
to work for a few minutes.
Leave the door in a horizontal position to allow the cleaner to penetrate into the
surface of the glass.
Dry the cleaner with a soft cloth.
Important:
Hitting or scratching the glass will damage the integrity of the glass.
Do not use knives or steel wool or any other abrasive material as a utensil to clean the
glass.
The glass in the door is ceramic, manufactured especially for use in wood burning
stoves.
Do not use to replace any other glass that is not ceramic glass manufactured for use
in these wood burning stoves. Change the glass through your supplier.
If the door glass breaks, it must be immediately replaced.
Contact your supplier to replace the glass, with the necessary instructions and parts
for the repair.
If you replace the glass yourself, use work gloves and safety goggles.
The procedure to change the glass and glass joints is as follows:
9. Open the door and pull it upwards and remove from the stove, leaving the turning
pins in the door. (Be careful to save the pins and the washers to replace the
door).
10. Place the door downwards horizontally on a flat surface.
