Henrac Tech Ef168, Руководство по эксплуатации

Страница: 9 / 11

6
In fact, very little maintenance is required for this receiver
collar, since the receiver collar is rechargeable and waterproof,
but the transmitter is not waterproof and must be protected from
the weather. A close lighting strike may damage the unit. Unplug
the transmitter and disconnect the wires during storms.
Test the system once a week to make sure the receiver collar
is working properly. Also testing the system will verify the field
width setting is correct. To test, attache the LED test light to the
receiver collar probes. Holding the receiver by the case( NOT by
the probes), walk into the signal field and pay attentions to the
warning tone and LED light. The dogs closer boundary and shock
or vibration will be stronger.
8.System maintenance tips
1. Pre-correction Warning Tone:
When the dog reaches the edge of the signal field in the
yard, it will hear a warning tone, if dogs don’t return to safe area,
the receiver collar will shock or vibration continuous until dogs
return to safe area. If dogs return to boundary again, the receiver
collar will work shock or vibration again.
2.Run-Through Prevention:
The receiver collar automatically increase the correction as
the dog enters the signal field, tone beeper, vibration and shock
will be stronger when dogs closer boundary. Strong shock or
vibration will not allow dogs go beyond the setting range.
7.How the correction works
4. It flashing light double red when charging, it light on green
when full charge, turn off the charge it return to shutdown status.
5.Receiver collar will automatic go to standby when collar
stationary 60S (power save function), and then shake the collar
will be go to work.
6.The receiver collar works: 20S continuous electric shock +
5S stop work, and then stop shock after 5 cycles, flashing red
light until dogs return to safety area.