18
needle) to clean the needle port. Replace the
needle and reset the desired flow rate. See image
to right for location of cleaning wire.
If the clog persists, it may be necessary to
perform a thorough cleaning.
No lubrication of any sort is required for the flow
regulator.
When disassembling the unit, make sure all parts
are clean and free of dirt and debris. Reassembly
is in the reverse order of disassembly. Make sure
not to damage the O-rings and diaphragm when
reassembling the unit.
Before any service to the system, turn off
power and air supply. Discharge any stored
air.
7.4 Differential Pressure Switch
The differential pressure switch has an internal spring that can be replaced to
change the fluid level switch point adjustment range, if necessary. Otherwise, the
differential pressure switch is a non-serviceable item and should be replaced if it is
not functioning.
Adjustment Needle &
Cleaning wire
Bottom of flow regulator
Front of Level Control
Bottom of Level Control
Содержание 2250048 REV
