Intelligence Aided Lifting Equipment
67
For all – touch handles: operate the control area
under the “All – touch Handle” > “Handle Zero
Point Value” menu, then there will be hundreds
of variations in the menu.
If the value does not change: check the internal
pressure sensor, and replace the sensor and the
handle board.
The
equipment
cannot
move
upwards
or
downwards
1.
The
equipment
cannot
enter
the
“Handle
Gripping
Mode” or “Suspension
Mode”;
2. The position is at
the
limit
or
the
equipment
has
an
alarm.
Check whether the handle is in the “Handle
Gripping Mode” or “Suspension Mode”;
Check if the current position is in the hardware
upper limit or hardware lower limit position.
Check if the current position is in the software
upper limit or software lower limit.
Check whether there is an alarm in the handle
display.
Check whether the internal drive of the host
displays an alarm code Al.xxx. The alarm
handling method is described below.
The lifting speed of
equipment is low
1.
Caused
by
parameter setting;
2. The handle zero
point value is offset;
3. Caused by program
built-in functions.
Check if the set speed in the “Lifting Speed
Setting” > “Speed Setting” menu is too low.
Check whether the “Lifting Speed Setting” >
“No-load Speed Setting” menu is in the “Open”
state. If it is open, then the upward running
speed will be too small.
Check the slowdown point setting in the soft
limit menu;
Check whether it is within 10cm before the
hardware limit; if yes, then it is normal.
The higher the lifting capability of equipment is,
the lower the value of lifting speed is. The
lifting speed of 600KG and 300KG is lower
than that of 200KG and 80KG (under the same
speed gear). For specific lifting speed, refer to
the Basic Parameter List;
Calibrate the handle zero point value as
