Hendi BAIN-MARIE KICHEN 238905, Руководство пользователя

Страница: 5 / 44

5
EN
After use / Drain the water
• Turn off the equipment by unplugging it from the
mains supply.
• Remove the trays.
• Allow the water to cool down.
• Poor the water out of the container
• Only for Bain marie with water drain: Place a
bucket under the drain pipe.
• Open the drain. The water will drain from the
container.
• When the water has drained from the container,
close the drain.
IMPORTANT: Always ensure that the water level isn’t below “MIN”! Check this regularly, also during use.
Cleaning and maintenance
• Always remove the plug from the socket before
cleaning the appliance.
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• Never use aggressive cleaning agents or abra-
sives. Do not use any sharp or pointed objects.
Do not use petrol or solvents! Clean with a damp
cloth and detergent if necessary. Do not use
abrasive materials.
• Clean the ventilation slots (if applicable) with the
vacuum cleaner.
• If used intensively, regularly remove lime scale
from the bottom of the water tank. Use for this
purpose vinegar or a special descaling agent.
• Avoid as much as possible water contacting the
electrical components.
• Only for Bain marie with water drain: if the wa-
ter being drained is dirty, leave the tap open and
rinse the appliance with clean water.
Technical Specification
Item no 238905 238912
Operating voltage &
frequency
230V~ 50Hz
Rated input power 1200W
Capacity 19L
Temperature range to 85°C
Dimension 340x540x(H)255mm
REMARKS: Technical specification is subjected to change without prior notification.
Troubleshooting
If the appliance does not function properly, please check the below table for the solution. If you are
still unable to solve the problem, please contact the supplier/service provider.
Fault Symptom Possible cause Possible solution
Appliance does not do
anything
green switch light does not
light and the green control
light does not light
No power at the power point Check the electrical
installation
Appliance does not do
anything
green control light does
not light
Overload circuit breaker
tripped
Reset the overload
circuit breaker ( 1 )
Appliance does not
reach the set temper-
ature..
green control light does
not go out
Thermostat defective Replace the thermostat
Element defective Replace the element