Hendi 272404, Руководство пользователя, Страница: 11 / 108

LEAK TESTING
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
NEVER LEAK TEST WHILE SMOKING.
The gas connections on this appliance are leak tested at the factory prior to
shipment.
This appliance needs to be periodically checked for leaks and an immediate
check is required if the smell of gas is detected.
!
Make a soap solution using 1 part of liquid dish-washing soap to 3 parts
water. The soap solution can be applied with a soap bottle, brush, or rag
to the leak tested points shown in the figure above.
!
The valve of the gas cylinder should be in the OFF position at this point of
the leak test. Once the soapy solution is applied to the gas connections,
the valve of the gas cylinder needs to be turned to the
ON position.
!
Soap bubbles will begin to form in the soapy solution if a leak is present.
!
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then
turn the gas supply on and recheck.
GAS REQUIREMENTS
!
Never use a gas cylinder with a damaged body, valve, collar, or foot ring. A dented or rusty gas tank may be
hazardous and should be checked out by a gas supplier.
!
Never connect this appliance to an unregulated gas source.
!
When the appliance is not in use, turn the gas cylinder OFF.
!
Always perform a leak test on gas connections whenever a cylinder is connected. If bubbles form in the leak test
solution, do not use. Never use a flame to test for leaks.
CONNECTING TO A GAS CYLINDER
!
Recommended to use 9 kg gas cylinder or refer to your gas supplier for suitable gas cylinder.
!
Approved gas regulator is used according to appliances categories and countries listed in data plate. Approved
flexible hose would be changed when the national conditions require it.
!
Assembly of the tubing must be conducted by some qualified tuber of destination countries.
!
Only change gas cylinders outdoors or in a well ventilated area away from naked flames and any other source of
ignition (candle, cigarettes, other flame producing appliance….).
!
The gas cylinder must always be used in an upright position.
!
Close the heater control knob by turning fully clockwise.
!
Close the gas cylinder tap and then attach the regulator onto the gas cylinder.
!
Tighten all connections firmly and with a spanner where appropriate. The cylinder should be located on the
cylinder base.
!
Check for leaks at all joints using soapy water. If a leak is found, tighten the joint and then re-test.
Leak Test Point
① ② ③ ④
11
EN