9
EN
Connecting the gas bottle
1 = Main tap
2 = Pressure regulator
3 = Gas hose
4 = Gas Bottle
5 = Rubber washer
Attach the pressure regulator to the gas bottle
using the large brass nut. Always ensure that the
rubber-sealing washer is present in the nut. (NB.
This rubber washer is not required for UK-type
pressure regulators). Tighten the nut well. Note
that the nut has a left-hand thread.
Check the connections for leaks using a soap and
water solution.
Every time a newly filled gas bottle is connected, a
new rubber washer must be fitted. In most cases,
your gas supplier will include it with the bottle.
Igniting the gas appliance
• Press the knob and turn left to the maximum po-
sition. Keep the knob pressed and press the igni-
tion button a few times. Keep the knob pressed in
for approximately 10 more seconds. The burner
will continue to burn.
•
Let the appliance burn for approximately 15
minutes before putting meat on the grid, as the
burners must first heat the chamber before it can
pass its heat to the upper grid.
Turning off the gas appliance
• Turn the knob fully to the right.
Note! After turning off the burners, wait approxi-
mately 10 minutes before reigniting the burners.
• When disconnecting the gas bottle or after turn-
ing off the burners, always turn off the regulator
on the gas bottle!
Cleaning and maintenance
• Let the appliance cool down before cleaning
• Beware: Never immerse the appliance in water
or any other liquid!
• Clean the outside of the appliance with a damp
cloth (water with mild detergent).
• The grid and/or baking tray of the grill should be
cleaned regularly. Let it soak in cleaning agent
first, then use an abrasive material like a scourer
or wire brush. If you use special cleaner, follow
the instructions on the packaging.
• Clean the ventilation slots (if applicable) with a
vacuum cleaner.
• Keep inside after use.
• Let specialised personnel clean at least once a
year the burner.
• Never use a high pressure cleaner.
• Maintenance after every use: Clean the griddle.
Clean the grease holder.
• If the injector must be replaced, replace it only
with an original spare part acquired from the
manufacturer. The diameter of the injector is
noted on the injector: 1.10 mm.
