Henden 3 Speed Pump Owners Manual
NEVER knock the plastic basket on a
hard surface as it will cause damage.
6. TROUBLE SHOOTING
If the pump runs but there is no water flow or
water flow is reduced, the following conditions
may apply:
1. The filter requires backwashing or it is blocked. Refer
to the relevant section in the filter manual.
2. The pump is not primed. Re-prime as per instruction in
‘Starting the Pump’
3. There are air leaks in the suction piping. Check all
piping and eliminate leaks, also check for a loose
strainer basket lid. Air bubbles in the water flowing
back to the pool would indicate a leak in the suction to
the pump allowing air to enter the pipework.
4. A leaking pump shaft seal may also prevent operating.
Evidence of this would be water on the ground under
the pump.
5. The pump is not able to get water from the pool. Check
that the valves to the pump are fully open and that the
pool water level is at least halfway up the skimmer box.
6. Blockage in the piping or pump. Remove the strainer
basket and check for any blockage to the pump
impeller entry. Check the skimmer box for blockage.
If the pump does not operate, the following
conditions may apply:
1. The power is not connected. For 220-240 volt only,
check the power point by plugging in a portable
appliance to ensure power is available. Also check fuses
and the main power supply switch
2. Automatic overload is tripped. The pump has an in-built
thermal overload which will re-set automatically after
the motor has cooled following an overheating period.
Determine the cause of the overload tripping and
rectify. Re-set the pump by switching the power OFF
for 30 seconds.
3. Blockage is preventing the pump from rotating.
4. Motor is burnt out - burning smell is evident.
Replacement is required
If you are unable to resolve any installation or operation
difficulties with your Henden 3 Speed Pump, contact the
supplier from whom the pump was purchased or your
local Reece Irrigation & Pools branch as indicated at the
back of this manual.
5. MAINTENANCE
5.1 Emptying the strainer basket
The strainer basket should be inspected frequently
through the transparent lid and emptied when a build
up of rubbish is evident. The directions below should be
followed.
1. Switch off pump.
2. Unscrew the strainer basket lid anti-clockwise and
remove.
3. Remove the strainer basket by lifting upwards from its
housing.
4. Empty the trapped refuse from the basket. Hose out
with water if necessary.
5. Check the strainer basket for cracks, replace the
strainer basket in the pump if OK.
6. Replace the lid and ensure that it seals on the large
rubber o-ring.
Firm hand tightness only is required.
The o-ring & thread can be lubricated with Hydra Slip or
equivalent products.
Failure to undertake regular
maintenance may cause damage not
covered by warranty.
Power supply to this pump needs to be
through an isolating transformer
on RCD, having a rated operating
current not exceeding 30mA.
8
|
HENDEN
INSTALLATION & OWNERS MANUAL
Содержание H83SP
Страница 2: ......
Страница 12: ...P N 403212 2...
