Helwett Packard HP 8512A, Руководство пользователя

Страница: 16 / 108

The recommended rack is the Instructions for rack mounting the test set in a system
configuration with the HP8510 are provided in the
HP8570
section and in the
System Rack Manual.
When installing the test set for use on a bench, place it on a grounded anti-static work surface (Figure
2-3) to lessen the chance of ESD damage. The anti-static surface should extend far enough in front of
the test set to provide effective protection at the test ports and cable ends.
If your test set is equipped with a grounding receptical, you may use that in place of a static mat.
Figure 2-3. Recommended
Static Free Workstation
Mating Connectors.
HP 8514B PORTS 1 and 2 are precision 3.5 mm male connectors and mate with
precision 3.5 mm female connectors. The HP 8512A has 7 mm test port connectors.
The TEST SET INTERCONNECT connector is a series D subminature female connector with 7 RF
connections.
The 8510 SYSTEM BUS connector is a female type connector and mates with the corresponding
male connectors of cables.
Power and Control Connections.
Figure 2-4 shows the following connections (with the exception of
line power) and the required RF source connections.
Connect the power cord to an electrical outlet and the line module to supply power to the test set.
Connect the test set IF interconnect cable from the TEST SET INTERCONNECT connector on the
rear panel of the test set to the TEST SET INTERCONNECT connector on the rear panel of the
HP85102 IF Detector.
2-4 Installation
HP Test Sets