Document Ref. EPD05183
(08.11.99)
ENGLISH
Part No. I380GB
issue 2
page 7
A
A
B
B
C
C
D
D
s
s
s s
s
s
s
s
Channel Address Mode
This mode enables the addresses for channels A, B, C and D to be defined.
The HES99300 supports the following addresses:
001 - 024
for use with the Ambience 24 Channel Lighting System.
001 - 128
for use with the Imagine Lighting System.
129 - 250
these are not currently used, and should not be selected unless otherwise instructed.
251 - 254
for use with the Ambience 4 Channel Lighting System.
255
for use when analogue control only is required.
000
for test purposes only.
IMPORTANT NOTE:
The HES99300 will not respond to S-DIM commands from an Ambience 24 or an Imagine System
if the channel addresses have been set incorrectly.
Changing the Channel Addresses
1. Press and hold the pair of buttons for the corresponding dimmer
until the display shows the Channel Address Mode, then release
both buttons.
For example, the left-hand pair of buttons are for channel A.
2. Press the top button to increase the address number or the bottom
button to decrease it.
To leave the address as it was previously, go to step 4.
3. To store the new address now displayed, press and hold both
buttons until the display briefly shows '888' to confirm that the
new value has been stored in the HES99300 internal memory.
4. To view or change the address for one of the other channels in the
block, repeat steps 2 and 3 using the appropriate pair of buttons.
5. If no further settings need to be changed, release the buttons; the
display will revert to Output Level Mode after ten seconds.
OR
Retain pressure on both buttons until the display changes to the
next required mode.
Procedure
Display & Buttons
