4215-109 G
10/30/09
Page 9
SECTION 6: SAUNALOGIC IS CONTROL INSTALLATION & OPERATION
OPERATING INSTRUCTIONS FOR IR EMITTERS .
Press the red POWER button once. The Infrared heaters will turn on and begin heating the room to current set
points. At the end of the selected time (60 minutes maximum), the control will turn itself off and the control
display will turn off. The infrared room temperature will be displayed on the control. The default settings for
Infrared temperature is preset to 120°F, the bath time is set to 60 minutes and 0 minute delay to start to heat.
These settings are adjustable (as described below) from 110° to 149°. Length of sauna can be set from 0 to 60
minutes. The time delay before start can be up to 23 hour and 59 minutes
SETTING THE DURATION AND TEMPERATURE
To set the sauna length of time, press the control POWER button to turn on the heater. Press the TIME "+" or
"-" buttons on the control to increase or decrease time for desired setting. The maximum of time is 60
minutes.
To set the temperature, press the control POWER button to turn on the heater. Press the TEMP "+" or "-"
buttons on the control to increase or decrease temperature for desired setting. The maximum temperature is
149°F (65°C).
Note: Typical bathing temperature is 115F to 125F displayed on the control. Starting ambient temperature
below 70F will cause the IR system to heat slower, which may result in less effective performance.
Press the Traditional Sauna button on the SaunaLogic IS and the default settings for the temperature is preset
to 176°F, the bath time is set to 60 minutes and 0 minute delay to start to heat. These settings are adjustable
(as described below) from 125° to 194°. Length of sauna can be set from 0 to 60 minutes. The time delay
before start can be up to 23 hour and 59 minutes.
SETTING THE DURATION AND TEMPERATURE
To set the sauna length of time, press the red POWER button to turn on the heater and press the
TRADITIONAL sauna button. Press the TIME "+" or "-" buttons on the SaunaLogic IS to increase or
decrease time for desired setting. The maximum of time is 60 minutes.
To set the temperature, press the control POWER button to turn on the heater. Press the TEMP "+" or "-"
buttons on the SaunaLogic IS to increase or decrease temperature for desired setting. The maximum
temperature is 194°F (90°C).
Note: Typical bathing temperature is 150F to 165F displayed on the control.
PRE-SETTING DELAYED START
With the electricity applied to the CB PK box, press the SaunaLogic IS POWER button once. The room
temperature will be displayed on the control. Press the “Pre-setting” button. Press the TIME "+" or "-"
buttons on the control to increase or decrease delay time for desired setting. The maximum of time is 23 hours
and 59 minutes. If no delay start is desired, set to 00:00 and press “Pre-Setting” button.
Note: The “ ” will flash between the numbers in the time display when system is in the delayed start mode.
