7
Setting of the heater on full power
When the heater is set on full power, the heater lid must always be opened!
Transfer from the simmering mode to full power is undertaken by holding down the control panel
OK button for about 3 seconds. Then the controller moves to the full power setting mode and the
flashing upper display shows the latest set stone space maximum temperature. When the display
is flashing the temperature of the stone space can be set to the desired rate by using the + and –
buttons. The setting range is 250°C – 300°C.
The change of the setting is stored in the memory by pressing the OK button or alternatively by
waiting for about 3 seconds and then the controller stores the change automatically and moves to
the next setting point.
If no change in the temperature is desired, the operation can be continued by pressing again the
OK button or alternatively by waiting for about 3 seconds and then the controller moves
automatically to the next setting point.
Next the lower display shows the latest set sauna time by flashing. Also the sauna use time can
be controlled by using the + and – buttons as long as the display is flashing. The sauna use time
can be set to 0 – 2 hours. The setting is stored just like with the temperature either by using the OK
button or by waiting for about 3 seconds.
OK
OK
=
=
=
=
=
OK
The heater is Press the OK The saved stone The stone space Changed stone Save the change
on the button and hold space temperature temperature can space temperature by pressing the
simmering mode down for appr. flashes on the be changed by + OK button or
3 seconds. upper display. and buttons. wait for appr.
3 seconds.
=
=
=
OK
=
OK
The stored sauna The sauna time Changed sauna Save the change The heater goes
time flashes on can be changed time by pressing the OK to full power mode
the lower display. by the + and button or wait for
buttons. appr. 3 seconds
