HELLO LITE HL-MB295, Руководство пользователя

Страница: 13 / 20

13
● Stand-alone mode
Do not connect the controller and the control line. When the automatic program of the
host mode of the lamp is set to be valid, the lamp will run in the stand-alone mode.
●
Master/Slave synchronization mode
If you need to connect multiple lamps to the master/slave synchronization mode, first
connect the XLR-XLR control line from the DMX output port of the first lamp to the DMX
input port of the second lamp, and from the DMX output port of the second lamp
Connect to the DMX input port of the third lamp, and so on, until all lamps are connected,
and then plug the loop into the signal output port of the last lamp to complete the
connection. Then the first lamp is the master, and the other lamps are the slaves.
Set the address code of the slave to 001; the operating mode of the master is set to any
one of the operating modes of the master, and the operating mode of the slave is set to
the slave operating mode corresponding to the operation of the master.
After power on, the fixture group runs in master/slave synchronization mode.
Master Slave
Slave
out
out
in
in
Lopper