HELLO LITE HL-MB295, Руководство пользователя

Страница: 11 / 20

11
DMX loop plug
In the "controller mode", the DMX output po
rt of the last lamp must be connected to the
DMX loop plug. This circuit is inserted between pin 2 and pin 3 of the "Canon" plug and
connected with a resistance of about 120
Ω
(OHM) (as shown in the figure below). Plug
this loop into the output port of the last lamp, which can effectively avoid the noise and
reflection caused by the DMX512 signal during the transmission process.
PIN 3
PIN 2
120Ω
3
1
2
DMX
回路插联接
在
XLR
插头的
2
针和3针之间联接
一个
120 (OHM)
的电阻，并将其
插在最后一台灯具的
DMX
输出插座上。
5 FUNCTION SETTING
●
Display operation
Signal in
DMX512
out In
In
out
Lopper
dmx loop plug connection
Connect a 120
Ω
(OHM) resistor
before pin 2 and pin 3 of the XLR
plug, and plug it into the DMX
output of the last lamp