Assembly Instructions
Grills, fan blades and the main body of the fan are packed separately to protect your fan from damages
during transportation.
1.
Be sure your fan is unplugged from the mains supply before proceeding.
2.
Insert the main pillar (14) into the hole of the fan base (16), and tighten the base and pillar nut (17).
3.
To adjust height, loosen the stand height adjustment key (13), slide the pipe to desired height, and
then tighten again.
4.
Connect the main motor housing (7) part to the upper pillar (12) by firmly tightening the fixing screw
(11) with a screwdriver.
5.
Remove the rear grill collar nut (2) from the motor assembly by turning the collar anticlockwise.
6.
Fit the rear grill (5) by matching it on positioning pins. Secure the rear grill (5) to the motor body with
the rear grill collar lock nut (4).
7.
Push the fan blade (3) onto the motor shaft (6) until the fan blade is fully seated. For models with
shaft pins, push the fan blade onto the motor shaft by matching the slots on the base of the blade
with the shaft pin.
8.
Secure the blade (3) with the fan blade nut (2). The blade nut (2) must be tightened by turning it
COUNTER CLOCKWISE. Check that the fan blade rotates freely by turning it with your hand.
9.
Open securing clips around the front grill (1) and loosen the grill screw and nut (19) at the bottom of
the front grill. Position the front grill hook on the uppermost part of the rear grill. Push the hook
down and press rim of the front grill onto the rear grill. Close all clips around and tighten the grill
screw (19).
Before First Use
Before use, remove all packaging and inspect the appliance for any damage. If there appears to be any
damage, please take the unit back to place of purchase for a replacement.
Operating Instructions
Before inserting the plug into a power outlet, make sure that the correct voltage being used corresponds to
what is indicated on the rating label, and that the socket has an earth facility.
1.
Place your pedestal fan on a firm, level surface away from moisture and heat sources.
2.
Connect to power outlet and turn the power supply on.
You may control your pedestal fan either with the remote control or with the buttons on the control panel.
3.
To remove the remote control, pull it out from the holder.
4.
To turn the fan ‘On’ press the ON/SPEED button on the remote control or the ON/SPEED button on
the control panel. By pressing this button repeatedly the fan will toggle between 1 (LOW), 2 (MED),
or 3 (HI) speed settings. The LED indicator on the control panel will indicate the speed selected.
5.
To make the fan oscillate, push down the oscillating knob (8) located on the top of the motor
housing (see parts location).
6.
To stop the fan from oscillating, pull up the oscillating knob.
7.
Your pedestal fan comes with an inbuilt 8 hour timer. Press the TIMER button on the remote control
or on the control panel to turn the TIMER ON. By pressing the TIMER button repeatedly the timer for
the fan will toggle between 1, 2, 4 and 8 hours. Press the TIMER button again to turn the timer
function OFF. The LED indicator on the control panel will indicate the time selected.
8.
Press the MODE button to select one of three airflow modes; Natural, Sleep and Strong Breeze. Press
the MODE button once. The MODE LED indicator light will be RED. Pressing again and again will
change the colour of the LED to GREEN and ORANGE.
