When removing the blender from the motor unit, wait until the blades have completely
stopped.
Always operate blender with blades lid in place.
Always use the appliance on a secure, dry level surface.
Never place this appliance on or near a hot gas or an electric burner or where it could touch a
heated appliance.
Always remove the blade assembly before pouring contents from cup.
Be sure to switch off the appliance after each use. Make sure the motor stops completely
before disassembling.
Do not run this appliance over a long period of time; otherwise the inner parts will be
damaged. The appliance should not be running for more than 30 seconds continuously. After
30 seconds, allow 3 minutes to cool down. If it overheats it will cut out automatically and
reset when sufficiently cool.
Do not leave this appliance unattended during use.
To reduce the risk of injury to persons or property, never use this appliance in an unstable
position.
Do not use outdoors.
Unplug from outlet when not in use, before putting on or taking off parts, and before
cleaning.
CAUTION: Never immerse in water, or unplug before inserting and/or removing parts.
CAUTION: DO NOT OPEN LID UNTIL BLADES STOP.
Do not let the cord hang over the edge of a bench, table or to touch hot surfaces.
Do not operate product with damp or wet hands.
Close supervision is necessary when the appliance is being used near children or infirm
persons.
The use of accessories not recommended by the manufacturer may cause injuries to persons.
This appliance is not intended for used by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliances by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not operate the appliance other than for its intended use. This appliance is for household
use only.
Do not operate the appliance by means of an external timer or separate remote-control
system.
The installation of a residual current device (safety switch) is recommended to provide
additional safety protection when using electrical appliances. It is advisable that a safety
switch with a rated residual operating current not exceeding 30mA be installed in the
electrical circuit supplying the appliance. See your electrician for professional advice.
Safety protection: The motor is equipped with protection setting, while over loading; it will turn off
automatically and re-operate after cooling.
