Hellenbrand 109248, Руководство пользователя

Страница: 7 / 18

7
1 V3722 Strain Relief Cover Backplate 1
2 V3804 Screw 6x1/2 PHPN T-25 SS 1
QTY. ITEM NO.
ORDER NO.
DESCRIPTION
1. Remove valve cover and drive bracket assembly.
2. From the valve cover side, use a punch and ham-
mer to remove the knock out plug.
3. Smooth the edge of the hole if needed.
4. Use pliers to remove one or both tabs as needed.
5. Run cable(s) through the strain relief feature on the
back plate.
6. Reinstall the drive bracket assembly and connect
the cables. Adjust cable length if necessary. Do
not let the cables come in contact with the drive
gear assembly.
7. Install strain relief cover and secure using screw.
STRAIN RELIEF COVER KIT
WIRING OPTION 1:
MAV Drive Cable must be connected to PC Board prior to programming or error 116 will result.
If installing any place other than brine tank, allow 4” of clearance above for service access. After plumbing completed, next
installation step is to provide access for MAV cable through back of valve. This is done by breaking off plastic tabs on back
plate to thread cable through back and attach to two-pin connection labeled DRIVE on PC board.
1. Remove valve cover.
2. Remove drive bracket by lifting two tabs at top of back plate and lift bracket out of bottom supports; set aside.
3. With needle nose pliers, break plastic tab off bottom of LEFT cable guides so MAV cable can fit through.
4. Route MAV drive cable through left side of back plate along with meter cable and weave through guides, push
snugly into place. Allow about 1 foot of cable to attach to PC board. Snap drive bracket into place and route MAV
cable to the left of PC board and plug into two-pin connection marked DRIVE on PC board. Verify all connections
are securely plugged into PC board.
5. Replace cover, plug 12V transformer into outlet that cannot be switched off and proceed to programming.
WIRING OPTION 2
:
WIRE MAV TO PM SERIES CONTROL