Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
43
Awning installation modular
Tension the cover by slightly retracting the awning. Then slip down and
remove the arm sleeves from the folding arm towards the middle.
Note!
The arm sleeves must not be removed prematurely under any
circumstances! There is a high risk of accidents and danger to life!
Check again all installation steps performed. Both the arm bearing and the
seal profile must be screwed down correctly prior to removing the arm
sleeves.
Slide the slot nut (2) with the fillister head screws (3) in the depicted
grooves of the front rail (4). Then attach the end cap (1). Then tighten the
fillister head screws on the end cap.
Legend
End cap
Slot nut
Cylinder head bolt
Front rail
1
2
3
Installation Instructions and Instructions for Use
44
Subject to technical modifications. – Date of Issue
September/2020
Awning installation modular
Attach the end cap (1) to the end plate (2). Press until the snap-fit
assembly snaps into place. The end cap (1) should then be flush with the
cassette and cover the end plate (2).
Legend
End cap
End plate
1
2
Installation Instructions and Instructions for Use
Subject to technical modifications. – Date of Issue
September/2020
45
Awning installation modular
Finally clip the inspection cover (1) into the statics profile (2) from the
bottom.
In addition, the inspection cover (1) must be secured on both ends by
means of the fastening screw (4).
Legend
Inspection cover
Statics profile bottom
Detail section view
Fastening screw pan-
head tapping screw
3.9x25 AW20
End cap
1
2
3
1
4
5
Installation Instructions and Instructions for Use
46
Subject to technical modifications. – Date of Issue
September/2020
Adjusting the awning
Inclination adjustment with standard arm bearing
To adjust the angle of inclination, the cassette awning PAN 7040 is equipped with an
adjusting mechanism, which enables an inclination from approx. 5° to 40°.
The angle of inclination and the horizontal position of the front rail are adjusted by the
factory.
If a modification is required, please proceed as described in the following:
Completely extend the awning.
Put an Allen key 6 mm (5) onto the adjusting spindle (4). The casing of the
awning raises or lowers by turning the key (see the figure on the following
page).
The respective arm can be adjusted easier if a second person slightly lifts
up the front rail (6).
Proceed analogously with the second adjusting mechanism. The awning
raises or lowers side by side.
Ensure that the angle of the folding arms to one another is not more than
5° during the adjustment procedure. Thus the adjustment procedure is to
be repeated several times on the left and right of the adjustment spindles
until the desired inclination is reached.
Never turn against greater resistance.
Check the correct adjustment on the front rail by means of a spirit level in
the extended condition.
