Level, horizontal floor space for SEG 4 DLLX
3.2
Level, horizontal floor space for SEG 4 DLLX
To achieve an exact headlamp
adjustment with the SEG
007 732-311, the following
requirements for the floor space
apply:
The bubble level in the SEG optics
box must be adjusted to a central
position of the air bubble by
means of the hand lever (for each
headlamp side, if necessary). To
this end, both axle fixing screws
must be slackened. After the
adjustment, the short fixing
screw is fixed by means of a SW5
hexagon wrench.
For measurements on a level
surface – according to DIN ISO
10604 – the hand lever must
be checked to ensure that the
zero-position has been set.
Zero-position:
Slacken axle fixing screws. Bring hand lever to the central position, so that the set screw for the axle fixing can be
seen through the bore in the hand lever directly from above. Screw down the set screws using a SW5 hexagon
socket screw key and counter the M10 nut.
6