24
Connectors and control units
10
Output Channels
Speaker outputs for connecting speaker
systems.
11
GND
Connector for the ground cable (negative
terminal of the battery or metal body of the
vehicle).
12
REM
Connector for the remote cable.
13
+12 V
Connector for the +12 V power cable to the
positive terminal of the battery.
14
Line Output
Line outputs for connecting external
amplifiers. Make sure that the remote output
(
Rem Out
) is used to turn on these devices.
15
Rem Out
The remote output has to be used to turn on/
off external amplifiers that are connected to
the RCA / Cinch line outputs. Both connec-
tions are internally wired in parallel.
10
11 12 13
14
15
10
1
4
3
2
5
6
8
1
USB Input
Connects the HELIX V EIGHT DSP MK2 to
your PC.
2
Control Input
Multifunction interface for e.g. an optional
remote control or other HELIX accessory.
. 3
Control pushbutton
Use this button to either switch between the
setups or initiate a reset of the device.
4
Status LED
This LED indicates the operating mode of the
amplifier and of its memory.
5
Optical Input
Optical input for digital stereo signals (SPDIF
format).
6
Line Input
RCA inputs for connecting pre-amplifier
signals.
7
Highlevel Input
Highlevel speaker inputs for connecting a
factory radio or an aftermarket radio without
lowlevel line outputs.
8
Clipping LED
This LED lights up red if one of the analog
inputs is overdriven.
9
Gain
Control for adjusting the input sensitivity of
the lowlevel
Line
and
Highlevel Inputs
.
9
7
