playmakerlcd.com
Instructions for Use
The Playmaker LCD ships with a battery isolation slip that helps to prevent
the batteries from being depleted during transit. Please remove this slip by
pulling straight back on the white tab that indicates to “
remove before use
”.
This tab is located in the battery compartment (
see product design diagram
).
To begin using the board remove the stylus from the holder. Use the stylus
to begin drawing on the screen. For best results avoid pressing your hand
against the screen while drawing. You should only use the included stylus
or similar object when drawing on the board. Please avoid using any sharp
objects as they may do permanent damage the to the LCD screen.
To erase all information press the “delete” key. You will see a momentary flash,
this is normal operation. After pressing the “delete” key, the board will process
an erase operation that will last approximately 2 seconds. If you write on the
board while this operation is still being processed it will not appear. Please
allow sufficient time for the erase operation to complete prior to writing on
the board.
Batteries
Power for Playmaker LCD is provided by two CR2430 batteries. The batteries
will last approximately one year with regular use. The board does not require
power while drawing, and only uses power while the board is being erased.
Replacement batteries are available at most retailers where batteries are
sold. To replace the batteries remove the battery compartment using a small
slot type screwdriver or similar tool. Be sure to insert the batteries as per the
battery orientation diagram. The battery orientation is important and the
device will not function if the batteries are not properly inserted.
