Helipal storm SRD101, Руководство пользователя

Страница: 17 / 21

17 Copyright@2016 HeliPal.com. All Rights Reserved
Binding with Spektrum DX8
MD2 (Gen 2) Transmitter
1. REMOVE ALL Propellers first (for safety reason).
2. REMOVE rear left spacer to gain access to USB.
3. Connect the drone to computer thru USB cable, open
BetaFlight Configurator software.
4. In BetaFlight configurator, goto "Ports" page, turn on Serial RX
tab for UART3, then press Save and Reboot
5. Goto "Configuration" page, "Receiver Mode" section, please
choose "RX_SERIAL", and in the "Serial Receiver Provider"
second, please choose SPEKTRM2048 for DSMX protocol,
then press Save and Reboot.
6. In "Receiver" page, make the "Channel Map" to TAER1234, then press Save.
7. Goto CLI page, type "set spektrum_sat_bind = 9" for DSMX .
8. Type "save" and press enter, after the FC reboot remove USB cable to cut power for the FC.
9. Wait a sec and reconnect the USB cable. Now the R110X
receiver’s LED should be flashing,
that means it's looking for Transmitter.
10. For your Spektrum DX8 transmitter, MAKE SURE you have the correct parameters on the
transmitter first ( * see P.18 ). Now press and hold BIND button and turn on transmitter, it will
enter binding mode and search for receiver. It should display binding complete on the
transmitter screen.
11. Final step, on the BetaFlight configurator, go to CLI tab and type "set spektrum_sat_bind = 0"
and then type "save". This must be done so that receiver doesn't go back to binding mode.
12. Restart transmitter, disconnect drone from computer and connect battery to reboot.
Download BetaFlight Configurator
http://goo.gl/Gy2nPv