Helion AURA 650, Инструкция по эксплуатации

Страница: 6 / 14

11. Locate the approx. 40” long length of
rigging. Attach the clevis to the metal backstay
crane and the other end to the rear eyelet on
the hull. The end with the adjustment bowsie
should be closer to the hull.
12. Unroll the jib sail and untape the clevis
from the top of the sail.
6 / 14
SR5 SR4
SR1
SR2
SR3
13. Unroll the jib sail and untape the clevis
from the top of the sail. Hook the clevis to
the forestay fitting keeping the eyelet
pointing toward the bow of the boat.
14. Unhook the eyelet from the deck hook and
attach it to the front silicone ring on the jib boom.
Slide the bowsie to tighten the line in order to
position the jib in front of the main mast.
15. Untape the line from the jib and thread
it through the 3 deck eyelets as shown in the
drawing above. Slip the loop at the end of the
line onto the clevis that is pre-installed by the
rear hatch and is attached to the winch servo.
16. Untape the line from the main sail and thread
it through the cord holder and 1 deck eyelet as
shown in the drawing above. Slip the loop at the
end of the line onto the same clevis as the
previous step.