Heli-Max TX610, Руководство пользователя

Страница: 5 / 16

5
CHANGING TRANSMITTING PROTOCOL OF YOUR
TX-610 TRANSMITTER
Your TX-610 is capable of using Tactic brand receivers. In doing so one must simply
change protocols from R-0 to R-1 in the transmitters programing.
1. With the transmitter off, place the HOLD switch in the on position.
2. While holding the trainer switch forward and pressing down on the MODE button turn
the transmitter on.
3. You will see R-0 or R-1 fl ash in in the LCD screen. R-0 allows you to fl y products
not supported with a Tactic brand receiver and R-1 allows you to fl y products using a
Tactic Receiver.
4. Use the D/R switch to toggle between the two selections.
5. Turn the HOLD switch off to begin operation.
TURNING THE TRANSMITTER ON
When turning your TX610 on, make sure the switches located near and at the top of
the transmitter are switched into the “back” position. Also make sure the transmitters
throttle stick is in the low position or a safety warning alarm will sound and a T-H will
appear on the LCD screen. Lowering the stick will turn the alarm off. If you hear a
warning beep and see the icons either 3D or T-H on the LCD screen, you have the UP-1
switch or HOLD switches activated. Please turn them off (back).
Your TX610 has two different setup modes, system setup and model setup. These
menus change slightly between airplane and helicopter model types so we will outline
the two types individually.
MODEL TYPE FEATURES
Airplane SYSTEM SETUP Airplane MODEL SETUP
s
Model Memory
s
Model Type
s
Range Check
s
Servo Reversing
s
Dual Rate (D/R)
s
Wing Mixing
s
Exponential Curve (EXPO)
s
Landing Gear Speed
s
Sub Trim
Heli SYSTEM SETUP Heli MODEL SETUP
s
Model Memory
s
Model Type
s
Swashplate Type
s
Range Check
s
Servo Reversing
s
Dual Rate (D/R)
s
CCPM Swash Mixing
s
Gyro Gain
s
Throttle Hold
s
Sub Trim
s
Revolution Mixing (ATS.MIX)
s
Exponential Curve (EXPO), Pitch Curve, Throttle Curve