H. Vollmer GmbH
ǀ
Allmendring 29
ǀ
75203 Königsbach-Stein
ǀ
www.HEITRONIC-SHOP.de 3 / 8 09/21
GB Installation and operating instructions
LED luminaires Juna
Art. No. 35201, 37420, 501214
These operating instructions belong exclusively to the above-mentioned product.
It contains important information on the commissioning and handling of the luminaire.
Therefore, please pay attention to these operating instructions, even if you pass this product on to third
parties.
It is therefore important that you keep these instructions in a safe place for future reference.
1. Introduction
Dear customer, thank you for purchasing our product.
You have purchased a product from Vollmer, which has been built according to the current state of the art.
The luminaire meets the requirements of the applicable European and national directives.
In order to maintain the condition of the product and to ensure safe operation, you as the user must observe these
operating instructions!
2. Safety instructions
In case of damage caused by non-observance of these operating instructions,
the warranty claim expires!
We do not assume any liability for consequential damages!
If the lamp is damaged, it is strictly forbidden to put it into operation.
Do not allow children to play unsupervised in the area of the luminaires or other electrical devices.
During operation, the LEDs become hot. The outer lamp housing also becomes hot. Do not touch the
luminaire with bare hands during operation.
Do not bring the luminaire into contact with extreme heat or open flame.
Do not modify or alter the entire product. Modifications to the luminaire will void the warranty.
The type plate must not be removed.
3. Intended use
The luminaire is designed for indoor/outdoor use.
This product is for lighting purposes only and must:
only be operated with a voltage of 230V ~50Hz.
only be connected according to protection class I (one).
only be operated firmly mounted on a stable, level and tilt-resistant base.
only be operated on normal or non-flammable surfaces.
not be subjected to strong mechanical stresses or heavy soiling.
4. Before installation/commissioning
The luminaire may only be operated outside its packaging.
Carefully remove the luminaire from its packaging.
Before operating the wall luminaire, make sure that it has not been damaged during transport. If there is any
damage to electrical parts, the lamp must not be operated. Repairs may only be carried out by a qualified
electrician.
Keep packaging material away from children and pets. Danger of suffocation!
5 Installation/Commissioning
This product may only be installed by a qualified electrician.
Before installation, the connecting cables on the building side must be disconnected from the power supply
and secured against being switched on again. To do this, disconnect the corresponding circuit breaker of the
building installation.
Make sure that the surface is suitable to support the weight of the lamp permanently and reliably.
Hold the lamp housing at the desired mounting position and mark the drill holes. Use suitable screws to
fasten the lamp. Make sure that no cables are damaged.
Now connect the connection lines of the house installation to the screw terminals of the lamp. First connect
the green-yellow protective conductor and then the other two lines. Usually the brown (or black) wire is the
phase conductor, connect it to the terminal marked "L". The blue conductor must be connected to the
terminal marked "N".
Do not kink cables; please ensure that cables and connectors are free from pulling and twisting forces.
Protect all cables and insulation from possible damage.
Check again for proper connection.
Switch on the circuit breaker of the house installation again.
