H. Vollmer GmbH
Installation Instructions Art. No: 38321
Page 2 of 3
Dated 28.12.2015
4. Commissioning
1. Unpack the contents and check to see if they are complete and intact.
Immediately contact your retailer if you notice a defect.
2. Unroll the LED strip from the spindle
3. Clean the surface where you want to attach the LED strip.
4. In order to guarantee the best hold of the LED strip,
the attachment surfaces must be dry, sufficiently even, clean and free of grease.
5. Pull the sticky film off the back of the LED strip and apply it immediately.
Tip:
The LED strips are self-adhesive but the glue can detach after a longer period of use,
so always use a suitable adhesive and apply additional adhesive points when
laying your LED strip for the first time.
6. Connect the LED strips at the required length.
7. Connect the USB plug with a USB socket.
8. The LED strip can be shortened to your ideal length if required.
Cut off the strip on the copper coloured marking using a pair of scissors.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
1. 3x LED strips
2. 1x LED strip with
USB cable
3. Connector
4. Connection cable
5. Remote control
1. On/off switch
2. White light
3. Flash function
4. Slow colour fade
5. Slow colour fade with
colour change
6. Colour change
7. 12 different colour
settings
8. RGB red, green, blue
9. Brightness