Installation instruction Art. No. 30630,30632,30634
Page 2 of 2
Status 07.2013
Installation:
Make sure that the connection values of your building installation for the power supply to the
light comply with the data stated on the name plate of this light.
The light is suitable for installation into normal inflammable surfaces. The light must not be
covered under any circumstances whatsoever with thermally insulating coverings or similar
materials.
The distance between the light and any flammable materials must not be less than 0.2m. The
distance between the upper part of the installed light and the ceiling must not be less than 2
cm. The light must not be installed into ceilings or walls that contain heat-insulating material.
Unpack the individual parts and check that they are complete.
Position the LED-driver in the designated area. The installation area must be well ventilated
due to the heat produced by the LED-driver. Comply with the ambient temperature and the
housing temperature of the LED-driver (see nameplate). During use, LED-driver can create a
slight humming noise. Ensure that you do not install LED-drivers in locations which act as
resonators and thereby lead to increased noise.
Make sure that the base and the fastening material are suitable and the weight of the lights
can be supported permanently and reliably.
Do not bend the cable, make sure that the cable and the plug are free from strain and
rotational forces. Protect all cables and insulations from possible damage.
To position the surface-mounted lights, drill holes of 33 mm diameter
Make sure you have a stable and reliable fastening.
Connect the plugs of the surface-mounted lights to the LED-driver.
After installation, connect the LED-driver to the mains supply. Use only the LED-driver
included, and do not connect the surface-mounted lights to other loads.
The name plate must not be removed.
Heitronic
®
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
