Heisei HPC FF Series, Руководство пользователя

Страница: 17 / 49

Heisei Technology Co., Ltd.
HPC FF USER MANUAL
2-11
2.2 First Time System Setup
To set up HPC FF SERIESfor the first‐time, you should have the following items ready. These items are
either included in the accessory box or available from your local computer parts store.

HPC FF SERIES Utility CD (Included)

Power cord (Included)

PS/2 or USB Keyboard (Not included)

PS/2 or USB Mouse (Not included)

Operating System (OS) Installation CD (Not included)

External Optical Drive (Not Included)
Hardware Installation Procedure
(Prior to turning the power on)
1. Connect a PS/2 keyboard to the PS/2 keyboard port, or a USB keyboard to a USB port.
2. Connect the PS/2 mouse to the PS/2 mouse port, or a USB mouse to a USB port.
3. Connect the External Optical Drive to a USB port.
4. Connect the male end of the power cord to an electrical outlet.
5. Connect the female end of the power adapter cord to the AC inlet located at the rear side of the
HPC FF SERIES
System BIOS Setup
If you are a commercial user, the HPC FF SERIES should have been set up and configured by your
distributor already. In the case where you may find it necessary to change some system configuration
information, you will need to run the Basic Input Output System (BIOS) setup program. Under the
following conditions, the CMOS settings may be changed:
1. The system is starting and being configured for the first time with new components.
2. The hardware devices attached to the HPC FF SERIES system have been changed.
3. The CMOS memory has lost power and the configuration information has been erased.
The BIOS setup program is stored in ROM, which can be accessed by pressing <DEL> key on the keyboard
immediately when the system is powered on. In order to retain the specified setup information when
the system power is turned off, the system setup information is stored in a battery‐backed CMOS RAM.
The battery is to ensure the settings will not be erased when the computer is turned off or reset. When
the computer is powered on again, the system will read the settings stored in the CMOS RAM and
compare them to the equipment check conducted during the power on self‐test (POST). If any error or
mismatch occurs, an error message will be shown on the screen and the computer will be prompted to
run the setup program.
Operating System and Driver
The standard HPC FF SERIES system may not be equipped with an operating system (OS). If you are a
commercial user, the system is likely to have been pre‐installed with a proper operating system and