Euro Homeware NZAust v1.1
INSTALLATION OF EURO HOMEWARE TOWEL WARMER
SPECIFICATIONS
Rating at 240 Volts AC
Voltage
White (W)
Stainless Steel
Model WE450
Euro Homeware Eco
39 Watts
30 Watts
240 VAC
Model WE575
Euro Homeware Standard
54 Watts
48 Watts
240 VAC
Model WE740
Euro Homeware Deluxe 3
70 Watts
51 Watts
240 VAC
Model WE700
Euro Homeware Deluxe 4
70 Watts
50 Watts
240 VAC
This Package Contains:
1 Towel Warmer and flex (with 2 pin plug – Australia Only)
Plastic Cover Plugs (2 per Bracket)
Plastic Mounting Bracket
Mounting Screws (2 per bracket)
CAUTION
Prior to installation please ensure the product is to your satisfaction. Once installed Heirloom cannot be responsible for defects in
the product finish
. This product is not intended for use by young children or infirmed persons without supervision. Young
children should be supervised to ensure they do not play with the product
. If the supply cord is damaged it must be replaced
by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
Installation:
Please ensure your towel warmer is installed by a registered electrician and ensure the electrical supply, plug & switch location,
and product location will comply with your local regulations. We recommend that the towel warmer be installed on a flat and
uniform wall, and into studs or other suitable anchor material. While not recommended, if fixing to hollow cavity walls, Toggle
Anchors or similar devices must be used.
Position the towel warmer so that the plug and mains power receptacle are easily accessible, with the cable entry to the towel
warmer NEAREST THE FLOOR. Avoid the supply cable coming into contact with the heated parts of the towel warmer
.
DO NOT PLUG THE UNIT INTO THE POWER SUPPLY BEFORE INSTALLATION IS COMPLETE.
Euro Homeware Deluxe 4
Euro Homeware Eco, Standard, Deluxe 3
Suggested positions for the wall brackets are shown in the drawings above
1.
The towel warmer can be mounted facing left or right with the cable entry at the bottom of the unit.
2.
Position the wall brackets in the required locations. (the screw inside each leg bracket can be slightly loosened to move
the legs into position. The screw can then be retightened)
3.
Hold the unit against the wall in the desired position in accordance with these instructions and mark the mounting holes
with a pencil. Pre-drill the holes through the wall cladding into the stud.
4.
Ensure the screw at the rear of the bracket is securely tightened and then screw the brackets to the wall
5.
Insert the plastic cover plugs into the mounting bracket screw holes
