HEINRICH'S HMZ 8672, Инструкция по эксплуатации

Страница: 59 / 80

59
1. Before cleaning the product, be sure to remove the electrical head and disconnect
the power supply.
2. Please clean the product in time after using.
3. When cleaning, please rinse the cup body and accessories with water and wipe them
dry. The blade is very sharp.
4. The outside of the motor can be wiped with a damp cloth. Do not put the main body
into the liquid or wash it in water or other liquid.
5. Store the product in a dry place and avoid direct uv exposure
6. Make sure the product is clean and dry before storage.
Note:
•
The above is the common fault analysis and troubleshooting method, for other faults,
please contact the company's customer service department, or directly to the company's
designated repair point for repair, do not disassemble repair.
The fault
phenomenon
Cause analysis troubleshooting
During the first
few USES of the
product; the
motor gave off an
unpleasant smell
If the product still emits this odor
after repeated use, please send it
to the nearest repair point for
testing
The new motor is used normally at
first
Stop in service
1.The voltage is too low
2. Motor temperature control
protection
1.Check if the voltage is too low 2.
Stop using for 20-30 minutes
Abnormal
vibration or loud
noise
1. The skein knife rest is not
installed in place
2. Product placement is not stable
3. The voltage is too high
4. Overeating
1. Take out the ingredients and install
the skein knife rest in place
2. Stable product placement
3. Check if the voltage is too high
4. Turn off the switch, disconnect the
power and remove the excess
ingredients
Card knife
The blade gets tangled or stuck in
the food
Turn off the switch, disconnect the
power, remove the ingredients and
cut into small pieces
The fault
phenomenon
Cause analysis troubleshooting
During the first
few USES of the
product; the
motor gave off an
unpleasant smell
If the product still emits this odor
after repeated use, please send it
to the nearest repair point for
testing
The new motor is used normally at
first
Stop in service
1.The voltage is too low
2. Motor temperature control
protection
1.Check if the voltage is too low 2.
Stop using for 20-30 minutes
Abnormal
vibration or loud
noise
1. The skein knife rest is not
installed in place
2. Product placement is not stable
3. The voltage is too high
4. Overeating
1. Take out the ingredients and install
the skein knife rest in place
2. Stable product placement
3. Check if the voltage is too high
4. Turn off the switch, disconnect the
power and remove the excess
ingredients
Card knife
The blade gets tangled or stuck in
the food
Turn off the switch, disconnect the
power, remove the ingredients and
cut into small pieces
Chapter 5 Cleaning and Maintenance
Chapter 6 Fault Analysis
The fault
phenomenon
Cause analysis troubleshooting
During the first few
USES of the product;
the motor gave off
an unpleasant smell If the product still emits this
odor after repeated use,
please send it to the nearest
repair point for testing
The new motor is used normally
at first
Stop in service
1.The voltage is too low
2. Motor temperature control
protection
1.Check if the voltage is too low
2. Stop using for 20-30
minutes
Abnormal vibration
or loud noise
1. The skein knife rest is not
installed in place
2. Product placement is not
stable
3. The voltage is too high
4. Overeating
1. Take out the ingredients and
install the skein knife rest in
place
2. Stable product placement
3. Check if the voltage is too
high
4. Turn off the switch, disconnect
the power and remove the
excess ingredients
Card knife
The blade gets tangled or
stuck in the food
Turn off the switch, disconnect
the power, remove the
ingredients and cut into small
pieces