
15
GASOLINE CHAIN SAW
2. Spark plug (F30)
Clean the electrodes with a wire brush and reset the gap to 0.65 mm as necessary.
3. Sprocket (F31)
Check for cracks and for excessive wear interfering with the chain drive. If the wearing is found obviously.
Replace it with new one. Never fit a new chain on a worn sprocket, or a worn chain on a new sprocket.
(1) Sprocket
(2) Needle bearing
(3) Clutch drum
(4) Spacer
(5) Clutch shoe
4. Fuel filter
(a) Using a wire hook, take out the filter from the filler port. (F32)
(b) Disassemble the filter and wash with gasoline, or replace with new one if needed.
(1) Fuel filter
NOTE
After removing the filter, use a pinch to hold the end of the suction pipe.
When assembling the filter, take care not to allow filter fibers or dust inside
5. Oil tank
With a wire hook, take out the oil filter through the filler port and clean in gasoline. When putting the filter
back into the tank, make sure that it comes to the front right corner. Also clean off dirt in the tank. (F33)
(2) Oil filter
6. Front and Rear dampers
Replace if adhered part is peeled or crack s observed on the rubber part.