Heinner HWM-V6010D++, Руководство пользователя

Страница: 39 / 88

www.heinner.com 6Kg, 220-240V~50Hz, 1000rpm
38
FAULT POSSIBLE CAUSE TROUBLE- SHOOTING
Unsatisfactory washing
result.
The contamination degree of your
laundries does not match the
programme you have chosen.
Select the programme appropriate for
the contamination degree of your
laundries. (See programme table)
Amount of detergent used
insufficient.
Adjust the amount of detergent based on
the amount and contamination degree of
your laundries.
Laundries in excess of
maximum capacity put in your
machine.
Load your machine with laundries, amount
of which will not exceed maximum laundry
capacity.
Unsatisfactory
washing result.
Water being hard.
( Contaminated, lime water etc.)
Adjust the amount of detergent based on
the instruction of detergent manufacturer.
Laundries distributed in your
machine non- homogenously.
Spread your laundries in the ma-
chine properly and homogeneously.
As soon as the ma-
chine is loaded with
water, water dis-
charges.
The end of water discharging
hose is too low for the
machine.
Set the water discharging hose on
appropriate height.
No water appears in
the drum during
washing.
No fault. Water is in the
unseen part of the drum.
Laundries have
detergent residues on
them.
Non-dissolving particles of
some detergents may stick to
your laundries as white spots.
Perform an Extra rinse by setting your
machine to “Rinsing” programme, or
clean the spots using a brush after your
laundries dry.
Grey spots appear on
the laundries.
The reason for such spots may
be oil, cream or ointment.
Apply the maximum amount of detergent
instructed by the detergent manufacturer
in the next washing operation.
Spinning operation is not
performed or runs late.
No fault. Unbalanced load
control system has been
activated.
Unbalanced load control system will try to
spread your laundries homogenously.
Spinning operation will begin after your
laundry is spread. Place the laundry in the
machine in a balanced fashion the next
time.