12
Instruction manual / EasyGrinder
pendulum hook ist to far outside, the cutter will rub on the heel (fig. 10). Adjust the
pendulum hook until the cutter rubs on both sides, above and on the heel (fig.11).
Holding the pendulum with the knuckle of your index finger directly under your
thumb, land your cutter on the rotating disc. Move the cutter immediately from side
to side by firm and even pressure, about 2 - 3 times. Move the comb as far to the outer
edge of the disc as about 2 - 5 mm of the cutter are over the edge. Then return the
comb to the motor shaft by a even movement, without any pressure unilateral, until
the comb touches the fixation flange (fig. 8). To finish the grinding (when the cutter
is sharp), move the cutter up to 25 mm to the outer edge of the disc. In this position
keep the pressure on the cutter for one or two seconds . Finish the grinding by a
little bit stronger pressure, and take the cutter off the disc by a even and continuous
backward movement.
6.4 When is the cutter sharp?
Check that you have a slight burr on the
four tips of your cutter that move up or
down when you touch them (fig. 12),
check that the whole surface of the cutter
is ground and there are no dull patches. If
in doubt, grind it again.
fig. 9
fig. 10
fig. 11
fig. 12
