4
OPERATION
(refer to Fig. 1,2, & 3)
VEHICLE PREPARATION
1. Locate vehicle on a hard, level surface, such as reinforced concrete, large enough to accommodate vehicle, jacks,
jack stands, and wheel dolly.
2. Set the emergency brake
unless
the rear drum, tire and wheel are all to be removed as an assembly.
3. Chock
all
unlifted tires in both directions AND
take every precaution necessary
to ensure the set up is stable and
will prevent
all
inadvertent vehicle movement.
RAISING THE LIFTING ARMS
1. Locate and enagage the release valve using the provided handle assy, then turn handle clockwise until firm
resistance is felt to further thread engagement.
Follow the vehicle manufacturers recommended removal and installation procedures for tire, wheel, hub,
or axle assemblies as needed!
DO NOT remove more than is recommended by the vehicle manufacturer!
2. After the tire, wheel assembly has been loosened from the hub or axle and is ready to be removed, position the
dolly under the assembly to be removed. Pump until load reaches desired height. Adjust lift arm tilt such that the tire,
wheel assembly will nest securely between the lift arms without falling forward (toward the front wheels).
LOADING THE WHEEL DOLLY
NEVER load this device with more than the weight of the wheel assembly to be removed!
ENSURE that the vehicle is securely positioned and supported by a pair of appropriately rated jack stands.
NEVER use a wheel dolly as a wheel pulling device. Before transporting wheel assembly, ensure that it is
free from the hub or drum assembly and secured to the wheel dolly with the provided restraint
.
1. When the weight of the loosened tire and wheel assembly is supported by the wheel dolly,
carefully
roll the wheel
dolly away from the drum or axle.
LOWERING
1. Engage and slowly turn the release valve counterclockwise, but never more than 1 full turn.
TRANSPORTING LOADED WHEEL DOLLY
1. Ensure that wheel assembly is secured to the wheel dolly by means of the provided restraint.
2. When wheel assembly has cleared the hub or the axle, lower the lift arms to the lowest position that will still allow
wheel dolly wheel and caster movement.
3. Push or pull to desired location.
Follow the vehicle manufacturers recommended removal and installation procedures for tire, wheel,
hub, or axle assemblies as needed!
If the operating handle is worn, operates abnormally, or will not positively
engage the release valve,
immediately discontinue use of the jack until a replacement handle assembly can be acquired.
!
!
!
!
!
