3
SAFETY INSTRUCTIONS
HW93716-M0
• Leer, comprender, y seguir las instrucciónes antes
de utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
!
ADVERTENCIA
• Read and understand all printed material provided with and on this product before use.
• Do not exceed rated capacity.
• Use of this jack is limited to the removal, installation and transportation of transmissions, transfer cases and transaxles.
• No alterations shall be made to this product.Only attachmens or adapters supplied by the manufacturer shall be used.
• Use only on hard, level, surfaces capable of supporting rated capacity loads.
• Use only the saddle assembly to lift. Never use any other part of the jack as a lifting surface.
• Ensure the center of gravity is centered on the saddle.
• For your safety, do not exceed 10
0
tilt angle of the saddle assembly in all directions.
• Adequately support the vehicle before starting repairs.
• Do not allow any part of your body under the load while jack is supporting a load.
• Use the chain provided. If loaded jack must be moved, make certain that the load is secured by appropriate means, is
stable, is in lowest position, is moved over smooth, hard, surfaces, and that the lifting platform is level.
• This is a lifting and lowering device only. Transfer load immediately to appropriate support device for service or repair.
• Failure to heed these markings may result in personal injury and/or property damage.
!
WARNING
To avoid crushing and related
injuries:
NEVER work on, under or
around a load supported only
by a jack. Immediately
transfer the load to an
appropriate work station.
!
WARNING
Figure 1: Model HW 93716 Components
Figure 2: Model HW 93718 Components
Chain
Lifting Arm
Wedge
Saddle
Tilt Adjustment
Knobs
Caster
Handle
Release
Valve
(not shown)
Oil Filler
Plug
(not shown)
Release
Valve
Swinging Arm
Lifting Arm
Frame
Handle
Caster
Saddle
Bolt
Tilt Adjustment
Knob
Air Vent Screw
(not shown)
For Model HW93716
(See Figure 1)
Swinging Arms: Align and insert bolt through the swinging
arm and top plate assembly. Securely tighten the bolt.
Repeat for the remaining swinging arms and bolts.
Chain:
Insert the eyebolt through the roller that is
attached to the attachment bar. Securely fasten with the
provided wingnut. Ascertain the chain, the eyebolt, hook,
and wingnut are all securely fastened.
For Model HW93718
(See Figure 2)
Wedges:
Align the hole in the wedge with the hole in the
saddle assembly. Secure with the nut, washer, and bolt.
Repeat for the other three wedges.
Chain: Insert the bolt through one hole of the saddle
assembly (lowest to the ground) if accessible. If the
assembly is extended, insert the bolt through one hole of
the adjustment plate. Secure with washer and wingnut.
ASSEMBLY
Familiarize yourself with the illustrations in the operator's manual. Know your jack and how it operates before use.
