2
SAVE THESE INSTRUCTIONS
For your safety,
read, understand, and follow
the information provided with and on this jack. The owner and operator of this
equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and
operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety
information shall be conveyed in the operator's native language before use of this jack is authorized. If any doubt exists as
to the safe and proper use of this jack, remove from service immediately.
Inspect before each use.
Do not use if there are broken, bent, cracked, or damaged parts (including labels). Any jack that
appears damaged in any way, operates abnormally or is missing parts, shall be removed from service immediately. If the
jack has been or suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it),
immediately discontinue to use until jack has been checked by a Hein-Werner authorized service center. It is recommended
that an annual inspection be done by qualified personnel. Labels and Operator's Manual are available from manufacturer.
PRODUCT DESCRIPTION
The Hein-Werner Hydraulicc Transmission Jack is designed to be used as an aid in the removal and installation of automotive
and light truck transmissions, transfer cases and transaxles.
It is intended for use under an overhead lift or in a garage pit.
SPECIFICATIONS
BEFORE USE
1. Verify that the product and the application are compatible, if in doubt call Hein-Werner Technical Service (816) 891-6390.
2. Read the operator's manual completely and familiarize yourself thoroughly with the product, its components and recognize
the potential hazards associated with its use
before
using this product.
3. Lower saddle fully, locate and remove air vent screw/ oil filler plug. (For HW93718, This will help to release any pressurized
air that may be trapped within the reservoir.)
4. Ensure the oil level is just below the oil filler hole, then reinstall air vent screw/ oil filler plug.
TWO YEARS LIMITED WARRANTY
For a period of two (2) years from date of purchase, SFA Companies will repair or replace, at its option, without charge, any
of its products which fails due to a defect in material or workmanship under normal usage. This limited warranty is a
consumer's exclusive remedy.
Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, to
SFA Companies
Warranty Service Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specifically prohibited by applicable law:
(1) THE CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE
PRODUCTS AS DESCRIBED ABOVE
(2)
SFA COMPANIES SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGE OR LOSS WHAT-
SOEVER.
(3) ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO TWO YEARS, OTHERWISE THE REPAIR,
REPLACEMENT OR REFUND AS PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY
OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED.
(4) ANY MODIFICATION, ALTERATION, ABUSE, UNAUTHORIZED SERVICE OR ORNAMENTAL DESIGN VOIDS THIS
WARRANTY AND IS NOT CCOVERED BY THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary
from state to state.
Model
Capacity
Low Height
High Height
Forward Tilt
Rearward Tilt
Sideways Tilt
HW93716
1000 lbs
3 1/4"
26 1/4"
70º
20º
25º L & R
HW93718
2000 lbs
10"
44"
40º
15º
10º L & R
