8
Step 17
To tighten place a hex wrench into middle slot and tighten bolt
in part #14.
Step 18:
14
1
2
GG
BOTTOM
INSIDE
Slide part # 14 into inside bottom of part #1 (Part #14 may need
to loosen bolt). Slide part #2 in between part #1 and other
outer frame piece, allowing for circular part of 14 to enter hole
GG. The bottom of part #2 should be level with the bottom of
part #1.
Step 19:
Repeat steps 17 and 18 for the all four corners of the inside of
the outer frame.
Step 20:
Turn the frame assembly over so that handle is on the floor.
Step 21:
4
1
10
2
15
15
TOP
Slide two part #10’s in the top of the outer most slot on part
#1, make sure that the extruded part of #10 is facing the front
of the frame assembly as it slides in. Line up part #4 (on the
outer slot of part #1) with the bottom of part #2. Use two part
#15 to bolt part #4 to part #1. Do this for both sides.
Step 22:
1
10
2
5
15
BOTTOM
Slide 1 part #10 into the outer part (1.5” side) of part #1 4.5
inches up. Line up the hole on part #5 and bolt on using part
#15
Step 23:
Make sure all bolts have a minimum of 17 ft-lbs of torque.
